Reset Waste Ink Counter (Waste ink absorber full [5B00])
1. Start with printer off
2. Press and hold resume Button (triangle in the circle) and click “Power” button. green led should be on
3. hold the Power button, release Resume Button.
4. Without releasing the Power Button, double click “Resume” button and then release Both Buttons.
5. Click “Resume” for four times then click “Power” button, to confirm the selected action (reset counter absorber).
6. Turn off the printer and turn on again
Reset Ink Level Canon Pixma MP460 (Manual Methode)
1. Disconnect the power cable
2. Hold down power button
3. Reconnect the power cable
4. With the power button still down, press twice the “Cancel/Stop” red button
5. Release the power button
6. The printer is now in factory mode…(wait about 30 seconds until it says “idle”)
7. Press the down arrow (next to the “OK” button) until it says “Shipping Mode 1”
8. Press the “OK” Button
9. Now with it displaying “Without Cleaning” press the power button
10. A test page should print
11. Now open cover
12. Disconnect the power again
13. Take both cartridges out like normal
14. Close cover
15. Reconnect power cable
16. Press power button
17. Replace cartridges
note: Other methode to reset ink level you can use MPtool software
Posted in: Printer
